Options

Hydraulic FunctionProvides control of up to three hydraulic functions at the push of a button. Status displayed on LCD screen at both the engine and remote controller.

(External controller may be required depending on number of controlled functions)

Outlet Hose PressureOutlet PSI is displayed on LCD screen at both the engine and remote controller.

PSI monitored at outlet side of pump to detect:
a) Burst Hose – Engine RPM is automatically reduced to idle
b) Pre-set Max PSI – If exceeded, RPM is automatically scaled back in 100RPM increments, until PSI is below Pre-set MAX PSI

Inlet Hose PressureInlet PSI is displayed on LCD screen at both the engine and remote controller.

PSI monitored at inlet hose on pump:
a) Used to manage working pressure when used in conjunction with ‘Boost Pump Cruise Control‘ option.

Boost Pump Cruise ControlSet up on one or multiple inline boost pumps.

Start your boost pump and leave to automatically increase RPM as manure pressure is detected. Inlet and outlet pressures are monitored and RPM is regulated based on your preset inlet working PSI value. If a problem is detected, engine controller will automatically signal out to main pump to reduce RPMs in 100RPM increments until boost pump is operating within preset values.

Stop all engines at the push of a button from any engine or remote controller on the network.

Options, Outlet Pressure, Inlet Pressure are required with Boost Pump Cruise Control.

Engine Oil PressureOil PSI is displayed on LCD screen at both the engine and remote controller.
Engine TemperatureEngine Temperature displayed on LCD screen at both the engine and remote controller.
– Celsius or Fahrenheit (you choose)
Pressure Sensor Diaphragm / SnubberProvides protection to pressure sensors from detrimental noise such as pump cavitation.
Auxiliary 2nd Actuator (end to end)Provides remote actuator control of lever or push button – 2 position control from ‘end to end’.
Auxiliary 2nd Actuator (3 position Control)Provides actuator control of lever or button – 3 position control ‘end – middle – end’ programmable position.
Remote Engine StartProvides user with the ability to remotely start the pump engine from 3Km+. Audible & Visual Warnings for 30 seconds Prior to Engine Start.

(Engine must be able to start without the need to adjust throttle)

Remote System Power DownRemotely disconnects power to the key switch and Broadcaster1 Engine Controller. Reset Power by pushing manual reset button at Engine Controller.
RepeaterAddition of a repeater to your set up will allow you to
a) Extend the signal to increase operating distance
b) Work in difficult terrain
External Engine StopExternal Push Button assembly hardwired and located in a position which will allow the operator to shut down engine quickly if required. Normally used in combination with Pump Trailers, where the engine controller is not accessible from the ground.
Weather Proof EnclosureEnclosure which houses Broadcaster1 engine controller, protecting unit from extreme weather conditions.